Capsule filling machine steps

Capsule filling machine integrates machine, electricity and gas, adopts microcomputer programmable controller, touch panel operation, frequency conversion speed regulation, equipped with electronic automatic counting device, which can automatically complete the position, separation, filling and locking of capsules. To reduce labor intensity, improve production efficiency, and meet pharmaceutical hygiene requirements. The steps are as follows:

1. Press the green button in the “Power Switch” and the power is turned on.

2. Slowly adjust the “Vibration Strength Adjustment Knob” and rotate it clockwise. At this time, the finishing disc that is integrated with the “Vibration Bracket” starts to vibrate, touch the finishing disc by hand, and adjust to a certain oscillation intensity by feeling.

3. Put the powdered capsule shell into the “Powder Capsule Shell Finishing Plate”, about 300 capsules each time. Put the capsule cap into the "capsule cap finishing tray", about 300 capsules each time. The finishing disc is made of plexiglass plate, and a plurality of round holes with a large upper and a small funnel shape are drilled thereon, and the diameter of the circular hole corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibration table plate is moved slowly before and after, so that it enters the hole of the platen one by one.

4. About 30 seconds, the powder capsule shell and the capsule cap fall into the round hole with the opening facing upwards. If the individual openings are facing down, you can use the capsule cap to gently press down on the sleeve to remove it.

5, horizontal hand-held powder capsule shell plate (drawn at the end of the picture, has been randomly prepared, there are round holes in the plate), in the whole

Push the lower part of the tray inward and the shell of the powdered capsule in the tray will fall down into the round hole of the board, and then take out the board. In the same way, the capsule cap is removed with a capsule cap.

6. A prescription powder plate with a bottom area of ​​500×500mm and a height of about 10mm on the four sides can be prepared in advance, and the powdered capsule is placed in the square plate of the powder powder. Then, the randomly arranged plexiglass frame is placed on the powder-filled capsule board, and the small shovel shovel powder is put into the frame, and the powder is scraped with the frame edge to fill the powder, and the excess powder is scraped off.

7. Use the matching capsule cap cover plate (draw at the end of the figure, there is a round hole on the set plate), put it on the capsule cap plate, and have the alignment hole, which is easy to place. Turn the capsule cap to the plate so that the capsule opening is facing down, and it is placed on the shell of the powdered capsule with the powder. The alignment hole is also easy to fit.

8. Put the nested capsule plate into the cavity under the “capsule wearing cap molding plate”, and pull the “pressing bar” down by hand and put it in place, no need to be too strong, because there is a positioning mechanism to control the pressing height. Remove the capsule plate, pour out the capsule, and fill it. You can cycle through the next board.